It just feels quite overkill to have OpenVPN and Wireguard running on the box. Is there any way for me to do this without leaking my IP? So far the only solution I have found is to run OpenVPN in parallel and then send my queries over the OpenVPN interface. I would much prefer to run Unbound in "normal" mode, and act as my own DNS server. The one you listed is I guess the non HTTPS version, they now have DNS over HTTPS at (194.242.2.2), so I am using that now. I am currently doing exactly as you said, putting Unbound in forwarding mode and forwarding to the Mullvad servers. ![]() ![]() ( Ports 1400 UDP and 1401 TCP do not have DNS hijacking enabled, which might work better for pfSense said in Unbound DNS Resolver through Wireguard Tunnel (Mullvad you for confirming this. * Which ports should I open in my firewall for OpenVPN ? If you want to send DNS queries to root servers through Mullvad then your only choice is OpenVPN and ports 1400, 1401 The only way to use Unbound with Mullvad's WireGuard is to use Unbound in forwarding mode and send queries to their public DNS server (193.138.218.74) or to DNS server available only through their WireGuard tunnel (10.64.0.1) Some time ago I asked their support and they confirmed that they hijack DNS request over WireGuard tunnel. It's impossible to send DNS queries to root servers through Mullvad's WireGuard tunnel. ![]() The problem is not on my devices, the problem is that the router cannot make requests to the authoritative servers over the wireguard tunnel. Said in Unbound DNS Resolver through Wireguard Tunnel (Mullvad VPN):
0 Comments
Leave a Reply. |